Energy UNITS FOR LIFT TABLE 1
Basic Description
This power unit is designed solely for that small lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be broadly utilized while in the market of logistic products including minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed through the solenoid valve together with the speed controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
General Description
This energy unit is created solely for that medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and the pace managed from the adjustable needle valve. Once the lift rises to a large positoin, but the energy provide is minimize, the reducing movement is managed from the guide override function.
Electrical power UNITS FOR LIFT TABLE 3
General Description
This power unit is intended exclusively for that substantial lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve along with the pace controlled by a strain compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This power unit is made solely to the massive lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as speed controlled by the adjustable needle valve. When the lift rises to a large positoin, but the electrical power supply is cut, the reducing motion is controlled through the manual override perform.
Special Notes
1. This energy unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic parts concerned ahead of set up of the electrical power unit.
3. Viscosity with the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is proposed.
four. Oil shifting is required immediately after the preliminary 100 operation hours,afterwards after every 3000 hrs.
five. The power unit shown is built to be mounted vertically.